Hard Water & Bore Stains on Perth Glass: How to Remove Them

    Updated June 2026 7 min read

    Perth has two glass-staining problems no other Australian capital has at the same scale: bore water iron staining and calcium hard-water spotting. Both are mineral deposits that bond to glass at the molecular level - and once they've been baked on by the sun for a few weeks, normal window cleaner does nothing.

    Bore stains: the orange ones

    Perth runs ~75,000 domestic bores. The bore water carries iron, which oxidises when it hits sunlight and oxygen - leaving orange or brown spotting on glass, walls, fences, paving and pool fencing. The longer it sits, the deeper into the glass surface the iron etches.

    What works: oxalic-acid based bore-stain remover, applied wet, scrubbed with a non-scratch pad, then rinsed thoroughly. Multiple passes for older stains. See bore stain removal.

    What doesn't: Windex, vinegar, dish soap, ammonia. They smear the orange around but won't lift it.

    Calcium spotting: the white ones

    Perth tap water is hard (about 110-170mg/L total dissolved solids). When sprinklers, hoses or shower spray hit glass and dry in the sun, the dissolved calcium and magnesium stay behind as white spots. On shower screens it builds into a thick haze that you can't see through.

    What works: a fluoride-based glass restorer or oxalic acid for fresh deposits, or a professional cerium-oxide polish for stubborn, baked-on shower screens. See shower glass restoration.

    The DIY method (light staining only)

    1. Wet the glass thoroughly with clean water first - don't apply chemical to dry glass in the sun.
    2. Apply a bore-stain remover (Bunnings stocks several). Wear gloves and eye protection.
    3. Scrub with a white non-scratch pad. Never use steel wool or green scour pads - they scratch the glass.
    4. Rinse immediately and thoroughly. Don't let the chemical dry on the glass.
    5. Repeat if needed. Older stains often need 2-3 passes.
    6. Once clear, dry with a microfibre or squeegee to prevent re-spotting.

    For anything older than a year, baked on through summer, or covering large areas - get a pro. Reactive chemicals on hot glass scratched by a wrong pad is an expensive mistake.

    Preventing it coming back

    1. Adjust your sprinklers. The #1 cause of bore stains is reticulation hitting windows. Aim down, not across.
    2. Apply a hydrophobic coating. An EnduroShield or similar treatment makes glass surface non-stick for 10+ years. Water beads off without depositing minerals.
    3. Squeegee the shower after use. Five seconds with a squeegee after every shower keeps calcium off the glass.
    4. Schedule cleans before summer. Stains that sit through Perth's January-February heat etch in deeper.

    When professional restoration beats replacement

    Most homeowners assume severely-stained shower glass needs to be replaced. It rarely does - a professional cerium-oxide polish restores 95%+ of stained glass back to clear, at a fraction of the replacement cost. Same for bore-stained windows. Replacement is usually a last resort.

    Got Stains You Can't Shift?

    Specialist bore stain and calcium removal for Perth homes. Free quotes, often same week.

    Call Now