Pressure Washing vs Soft Washing: Which Does Your Perth Home Need?

    Updated June 2026 6 min read

    Pressure washing and soft washing get used interchangeably online, but they're different jobs with different tools. Get the wrong one and you'll strip your render off the wall, blast the seal off your limestone, or chase mould around without actually killing it. Here's the plain-English version.

    Pressure washing in one line

    High pressure water (2,000 - 4,000+ PSI) blasts dirt off hard surfaces. No chemicals usually, it's the force of the water doing the work.

    Soft washing in one line

    Low-pressure water (under 500 PSI) plus a biodegradable cleaning solution does the work chemically. Kills mould, algae and lichen at the root instead of just blasting the surface clean.

    When to pressure wash

    • Concrete driveways and paths - see our driveway cleaning service.
    • Pavers and brick (with care, see below).
    • Garage floors with oil stains.
    • Outdoor furniture and metal fences.
    • Decks (low-pressure end, otherwise you'll fur the timber).

    When to soft wash

    • Roof tiles - Perth's lichen and moss problem needs chemistry, not blasting.
    • Colorbond and metal roofing, pressure can damage the protective coating.
    • Render and stucco walls.
    • Painted weatherboard and fibre cement.
    • Solar panels, never pressure wash these.
    • Limestone, sandstone and other porous stone.

    Surfaces you should NEVER pressure wash

    • Roof tiles - water gets under the laps and into your ceiling. Cracks tiles. Voids tile warranty.
    • Render - strips it clean off the wall in chunks.
    • Limestone walls or paving, chips and pits the surface. See our limestone cleaning page for the correct method.
    • Solar panels - micro-cracks the glass and voids the warranty.
    • Old timber decks, splinters the surface fibres.
    • Windows, obvious, but it happens.

    The Perth-specific bit: pavers and driveways

    Perth's exposed-aggregate and limestone-paver driveways are the most common DIY pressure-washing disasters. Both surfaces need the right nozzle distance and PSI - too close and you'll strip the sealant or pit the aggregate. Most homes can be safely cleaned with a 25-degree nozzle held 30cm back, then re-sealed afterwards.

    Roof cleaning: this is where most people get it wrong

    Perth's terracotta and cement tile roofs grow black lichen and orange algae thanks to coastal humidity. A pressure washer "cleans" them in the moment - but the spores stay alive and the roof is black again within months. Our roof cleaning Perth service soft washes with a sodium hypochlorite solution that kills the biology at the root, so the roof stays clean for 3 - 5 years.

    The quick decision tree

    1. Is it hard and inorganic (concrete, brick, metal furniture)? → Pressure wash.
    2. Is there mould, algae or lichen visible? → Soft wash.
    3. Is it a roof, render, painted surface or stone? → Soft wash, no exceptions.
    4. Is it old, painted, or porous? → Soft wash to be safe.
    5. Not sure? → Get a pro to look. The repair bill for the wrong method is always higher than a quote.

    Need a Pro to Look at It?

    Free quotes for pressure washing and soft washing across Perth. We'll tell you straight up which one your surface needs.

    Call Now